Operation Manual

The outdoor sensor cable should be routed outside through a window, door etc, ensuring that the
cable does not become trapped, as any damage to the cable is not covered by the manufacturer’s
warranty.
The outdoor sensor cable can be secured by the sticky pad provided or a screw (not provided).
The outdoor sensor cable must be positioned away from direct sunlight as this could result in an
inaccurate reading.
Keep in mind that your transmitter has a 30-meter open air transmission with no obstructions. Actual
transmission range will vary depending on what is in the path of the signal.
Each obstruction (roof, walls, floors, ceilings, thick trees, etc.) will effectively cut signal range in half.
Insert the holder into the bottom of the transmitter for desktop use or insert it into the back of the
transmitter for internal wall mount purpose
DCF SINGAL RECEPTION AND SIGNAL INDICATOR
(The DCF77 signal is a radio time signal which operates across much of Central and Western Europe)
After your weather station is powered up, it starts to receive DCF signal. The icon flashes.
Weak or no DCF signal (only icon flashing)
Receiving strong DCF signal ( icon flashing)
Successful Reception (
icon becomes static)
Failed Reception ( icon disappear)
Remark: When your weather station is receiving radio controlled time signal, all buttons except the
snooze / light button will not function.
If only
flashes on the display then press and hold for two seconds the wave (
o
C /
o
F ) button to
cancel the automatic DCF signal.
DCF TIME SIGNAL RECEPTION
Your weather station will automatically update itself to the exact time after receipt of the DCF time
code. The weather station will automatically attempt to receive the DCF signal every morning at 1:00
am, 2:00 am, 3:00 am, and 4: 00 am and onwards. If it receives the DCF signal at 3:00 am it will stop
receiving until 1: 00 am the next day.
To start DCF reception manually, press WAVE / (°C/°F) button for 2 seconds. To stop DCF
reception, press and hold WAVE / (°C/°F) for 2 seconds.
TO SET CALENDAR, TIME ZONE, 12/24 HR TIME FORMAT, TIME
EN.5
1. Press and hold SET / ALM SET for 2 seconds, the time di ange to year 2008 and
flash with Yr to the right hand side of the year digits.Press
gits ch
/ to set the correct year.
Downloaded from www.vandenborre.be