Installation Guide

INSTALLATION
.
USE
This unit contains a built in 4 hour timer which is activated immediately. The unit will power off after 4 hours of
use. This helps maximize battery longevity. The unit can be turned back on manually or by using the remote
control to commence a new 4 hour session. The unit can be turned off manually or by remote control
at any time.
Battery Powered Color Changing
Vertical Wall Sconce
B
A
B
Telephone: + 1 813 343 5775
Email: [e-mail]
Web: www.itsexcitinglighting.com
It’s Exciting Lighting is a Smart Living Home & Garden brand © 2016.3
Smart Living Home & Garden
A
CONTENTS
REQUIRED
• A - Sconce Cover* x1
• AA Batteries
(Not Included)
• B - LED Back Plate x1
• C - Remote Control x1
*Sconce Cover may vary in style/shape
Mounting Holes
C
B
A
Front of LED Back Plate
Back of LED Back Plate
Power Button
Mounting Posts
Battery Cover
1. Remove rear battery cover and place 6 AA alkaline batteries (not included) with the polarity
as shown in the battery door. Replace battery cover .
IMPORTANT: pay careful attention to the polarity of the batteries and ensure they are inserted
in the correct direction as shown on the battery cover illustration. Failure to install batteries in the
correct direction may cause damage to the product.
2. Determine where the product is to be mounted and insert nail or screw (not provided) in the wall.
Mount LED Back Plate on the wall by sliding it onto the nail or screw head like hanging a picture frame.
3. Slide the Sconce Cover onto the LED Back Plate by fitting the holes in the top of the Sconce Cover
onto the Mounting Posts to hold it in place.
4. Push the Power Button located on the bottom of the unit to power the unit on. If the unit has an amber
flicker mode, press again to switch from white LED to amber LED. Push the Power Button again to
power the unit off.
Note: There are 10 light modes: color changing, white, red, blue, green, yellow, light blue, light green,
light purple, and purple for your selection. Simply push the power button to go to different modes. Push
and hold down the power button to turn light OFF.
5. Remote control Instructions: Remove pull tab between the battery and the connector. To activate light,
press any of the colored buttons or the color change button. To turn light OFF at any time, press
the power button.