User's Manual

HOW to Install the li-ion Battery
1. Remove the battery compartment cover of the transmitter by sliding it down.
2. Connect the battery plug along the slot into the transmitter’s battery connector.
3. Insert the Li-ion battery pack into the battery compartment by sliding it up.
NOTE : The Li-ion battery must be fully charged at least 4 hours before initial use. Please refer to the
“Charging the Battery (Full Charge)” section.
POWER CONNECTION
CAUT ON : You must use a 120Volt AC/ 9-12Volt DC adaptor that delivers at least 300-500mA for
charger. The plug must correctly fit the machine’s DC 12V jack.
1. Plug the AC Adaptor into a standard AC outlet.
2. Plug the adaptor plug into the DC 12V jack on the rear of the docking station.
CHARGING THE BAT TERY (FULL CHARGE)
1. Once the docking station has power connection, place the transmitter in its cradle on the docking
station.
2. Leave the transmitter on the cradle for at least 4 hours for a full charge.
NOT E : The Li-ion battery is continuously charged when the transmitter is on the cradle of the docking
station.
PREPARING FOR INITIAL USE
1. setting the Battery on transmitter.
2. Ensure that the Li-ion battery is installed and fully charged before initial use.
3. Check line and power connections.
4. Push the transmitter TALK button to confirm. If you do not get a lcd display, please refer to the
Troubleshooting chart.
OPERATION
To St art a record (TALK MODE)
1. Press TALK button on the transmitter. The IN-USE indicator will light up solid when it finds a clear
channel.
2. Check the recording indicator (after the recorder is working).
To End a record (Standby Mode)
If you picked up the transmitter from the docking station:
♦ Since the DT-1TR features “Auto-Standby,” simply return the transmitter to the docking station to end
the record. The DT-1TR will automatically go to standby mode.
If you picked up the transmitter away from the docking station:
♦ Press the TALK button to end the record if you were away from the docking station when you picked