U S E R ’ S MA N U A L (IMPORTANT SAFETY INSTRUCTIONS & FCC NOTICE)
√ IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basis safety pr ecautions should always be followed to r educe the r isk of life electr ic shock , and injur y to per sons, including the following. 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the product. 3. Unplug this product from the outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
E. If the product has been dropped or the cabinet has been damaged. F. If the product exhibits a distinctive change in performance. 13. Avoid using a TRANSIMITTER (other than a cordless type) during an electrical storm. may be a remote risk of electric shock from lightning. 14. Do not use the TRANSIMITTER to report a gas leak in the vicinity of the leak.
√ SAFETY INFORMATIONS FOR DT-1 Your T RANSIMIT T ER contains a low power tr ansmitter . When the Push-to T alk button is pushed it sends out r adio fr equency (RF) signals. T his device is author ized to oper ate at a duty factor not to exceed 50% in August 1996, the Federal Communications Commission (FCC) adopted RF exposur e guidelines with safety levels for hand-held wir eless devices. CAUTION : To maintain compliance with the FCC’s RF exposure guidelines, hold the transmitter and antenna at least 0.
√ IMPORT ANT Read this manual before attempting to setup or use this instrument. If contains important Information regarding safe installation and use. Keep this manual for future reference. Also save the carton, packing and proof of purchase to simplify and accelerate any needed action. √ WARNING To prevent fire or shock hazard, do not expose this product to rain or any type of moisture. If accidentally dropped into water, this product should immediately by unplugged from the AC outlet jack.
5. Recharge only the battery type that is provided with or identified for use with this product. If a different type of battery is used, it may leak or explode. 6. Do not attempt to rejuvenate the battery provided with or identified for use with this product by heating them. Sudden release of the battery electrolyte may occur, causing burns or irritation to eyes or skin. 7. When inserting the battery into this product, the proper polarity or direction must be observed.
HOW to Install the li-ion Battery 1. Remove the battery compartment cover of the transmitter by sliding it down. 2. Connect the battery plug along the slot into the transmitter’s battery connector. 3. Insert the Li-ion battery pack into the battery compartment by sliding it up. NOTE : The Li-ion battery must be fully charged at least 4 hours before initial use. Please refer to the “Charging the Battery (Full Charge)” section.
up the record. The DT-1TR will go to standby mode. TROUBLE SHOOTING SYMT POM No recording sign SOLUT ION ♦Check for the line cord connectors at both endsthat they are pushed in firmly until they click.(docking & recorder) ♦ IF you had a power failure or had unplugged the docking station,replace the transmitter on the docking station for two to five seconds to reset the system.
This DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDERSIRED PERATION. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
