Quick Start Guide

3
Thank you for purchasing the iStorage diskAshur DT
2
. Your diskAshur DT
2
is preformatted in NTFS and shipped with
a default Admin PIN of 11223344 and although it can be used straight out of the box with the default Admin PIN,
for security reasons, we highly recommend that a new Admin PIN be created immediately by following the
instructions under the heading ‘Changing the Admin PIN’.
To setup the diskAshur DT
2
, insert the supplied USB cable to the back of the drive and connect to your computer.
Next, connect the supplied AC adapter to the back of the drive and a mains power outlet. Once connected press the
power switch on the back of the drive to the ON position, your diskAshur DT
2
undergoes a rapid self-test to verify
all security components are working properly each time the diskAshur DT
2
is powered on. The LEDs will go
through 3 test stages, blinking in sequence RED, GREEN and BLUE, followed by two GREEN blinks and then to
RED (Standby State) on a successful test. Any test failure will force the diskAshur DT
2
to securely reset itself and
automatically resume the self-test without affecting the security characteristics or any data stored on the drive.
With your diskAshur DT
2
powered on and connected, follow the instructions in the table below to unlock.
1. In Standby State (solid RED LED), enter
the default Admin PIN ‘11223344’ and then
press the ‘UNLOCK’ button.
GREEN and BLUE LEDs will alternately blink
several times and then to a solid BLUE LED
changing to a blinking GREEN and finally to a
solid GREEN LED.
Quick Start Guide
First Time Use
LED LIGHTS
LOCK
SHIFT
UNLOCK
- Standby State/Locked
- User Mode/Unlocked
- Admin Mode
Alphanumeric
Keypad
USB 3.1
PORT
ON/OFF
SWITCH
DESK
LOCK SLOT
diskAshur DT
2
rear view
AIR
VENT
MAINS
POWER