User manual
#10
iStorage diskG
®
SSD Manual – v 2.1
www.istorage-uk.com
diskG SSD
This section provides information about managing your password in the Admin Mode.
You can change the Admin Password by doing the following:
1. Enter Admin Mode (refer to page 9 for details).
2. Press and hold + 9 until the LED indicator light flashes BLUE.
3. Enter the new password and press (The Password must be a minimum
of 6 digits and a maximum of 16 digits). The LED indicator light flashes
GREEN three times. See note below.
4. Re-enter the new Admin Password and press . The LED indicator light stays
solid GREEN for two seconds and then solid BLUE indicating that the Admin
Password has been changed successfully.
Note: If the LED indicator light flashes RED three times, this indicates that the password is less than 6 digits
or more than 16 digits. Enter a password that contains 6 – 16 digits after the LED indicator light flashes
BLUE intermittently.
1. If the LED indicator light flashes RED intermittently and then BLUE intermittently,
go back to step 3. This is due to one of the following conditions:
• You waited longer than 10 seconds before entering a password.
• The new password was entered incorrectly.
2. If no activity is detected within two minutes in the Admin Mode, the diskG SSD will
return to the Standby Mode.
11. Changing the Admin Password