Datasheet

All mechanical dimensions are valid at 25°C ambient temperature, if not differently indicated.  All data except the mechanical dimensions only have information purposes and are not to be
understood as assured characteristics.  Technical changes without previous announcement as well as mistakes reserve.  The information on this data sheet was examined carefully and will be
accepted as correct: No liability in case of mistakes.  Load with extreme values during a longer period can affect the reliability.
Released 09/2011 Rights reserved for change in technical data!
HYGROCHIP 5/5
Humidity sensors
LabKit with USB-Interface
Configuration of Software PCLOG
Then start the software PCLOG and open the op-
tion "Extras" in menu and click "Activation" there.
The following dialogue box opens:
Now for the "Device", select the device driver "14
Hygro-Thermometer HYTE-LOG 4800 BD". The
activation code will be registered automatically.
Confirm the dialogue with 'OK'.
Now open the option "Extras" in menu and then go
to the sub-menu "Interface". Put in the correspond-
ing interface.
The used interface – if not known – can be
determined in the device manager under Windows.
(Control panel P System P Hardware P Device
Manager P Connections)
The PCLOG start screen appears. The measured
values of the sensors are displayed on the left side.
The measurement begins in menu with “Measure-
ment” P “Start recording”. Confirm the window
selection with OK.
Now click on the thermometer icon and the icon
with the water drops in the left side panel. The
corresponding measuring curves are displayed.