Use and Care Manual

(4) Equipment Installation
Step 1. Confirm proper installation conditions, then unpack the equipment and verify that all
accessories are present. Prepare the installation tools and confirm that the water inlet and outlet
pipes, power supplies, sewage pipes, and floor drains at the installation site meet the appropriate
requirements.
Step 2. Close the indoor water inlet valve completely, then open any faucets in the room to remove
the remaining water in the indoor water pipe.
Step 3. Connect the water inlet and outlet pipes. Pay attention to the direction of the water inlet and
outlet and prevent the connection pipes from bearing stress. The water inlet is connected to the
stainless steel braided hose. The other end is connected to the water inlet channel. The water outlet
is connected to the stainless steel braided hose. The other end is connected to the water outlet
channel.
Step 4. Connect the equipment drain hose and clamp to ensure a secure connection.
www.123filter.com | [phone] | [e-mail] Page 12