Use and Care Manual

Step 15– Select a readily accessible and well-lit location to fix the system. The system should always be located close to the
entry and can either be installed horizontally or vertically.
Step 16– When all plumbing connections are finished, slowly turn on the water supply and check for leaks.
Step 17– Allow the water to run for a few minutes to clear any air or dust in the filter chamber.
Step 18– Connect the power for starting up.
System Operation
Water Quality Guidelines
A. The ultraviolet water filter is intended for visually clear water, not colored, cloudy or turbid.
i Ambient Water Temperature: 2-45ȭ
i Iron: <0.3 ppm (0.3 mg/l)
i Hardness: <7 gpg (120 mg/l)
i Turbidity: <1 NTU
i Manganese: 0.05 ppm (0.05 mg/l)
i UV Transmittance: >75%
B. Recheck the installation before plugging the filter into power.
C. Do not install the equipment when UV Lamp or Sleeve Tube is broken; repurchase one and continue.
D. Ultraviolet Water Treatment System is designed for continuous operation, and frequent switching will reduce
Ultraviolet radiation and service life.
- 9 -