Instructions / Assembly

F、Trouble Shooting；

Sympton

Solution

Leakage on the UV sterilizer steel pipe nuts

replace the sleeve silicone ring

Water flow out from the quartz sleeve

Replace the quartz sleeve

Leakage on the inlet/outlet

Wind water stop on the

connector ,then fix back to the inlet

Ballast sends alarm, green light is off, lamp

doesn’t turn on

Lamp reaches its service life, replace

Lamp still doesn't turn on after replacing

Check the lamp connector wires

Green light is off without alarm and lamp

doesn’t turn on

Ballast is broken, replace it

Lamp turns on, indicator lights and alarm are

abnormal

Indicator lights are broken, replace

them

Timer failure

Do some adjustments according to

the user manual or replace it

UV radiation intensity monitor failure

Do some adjustments according to

the user manual or replace it

Leakage on UV radiation detection head

Replace silicone ring of detection

head

G、User Manual of Timer:

1. Diagram of panel：

2. The instrument has been set an initial status before leaving factory. Don’t set it by

your own if not necessary. Once power is on it will start to work.

3. UV lamp manufacturer suggests lamp should be replaced after being used for about

8000 hours to ensure its designed germicidal effect.

4. Once a UV lamp is replaced, the timer needs to be retiming. Press “SET” key for

5-10 seconds. Timer will come to zero automatically and start timing again.

5. If you need to reset the timer. First press the shift key for about 5-10 seconds. The

panel will show “29-1”. Then press the up key to set the number to “22-1”. About

10 seconds later the automatic reset is done. Both of the lines will show “0000”.

Now press the shift key until the above line shows “9999” and below