Instructions / Assembly

Step 1 – Install Water Supply Connector
1.1 Turn off the cold-water line under your sink. Open the kitchen faucet to release any
pressure and ensure the water has stopped before proceeding. You can use a towel or
bucket to catch any water drips.
1.2 The system comes with a complementary
quick installation kit that connects the
system to the existing under sink water
supply. Disconnect the cold waterline
from the water inlet with a wrench.
1.3 Connect both hoses to the system by
screwing the 1'' Male NPT into the female
thread on both ends of the system. 78015-
24(Hose A) should connect to the
incomingline, while 78014-24(Hose
B)should connect to the outgoing line. To
secure the connection, wrap 3-4 rounds of plumber's tape(included) on the male
threads to prevent leaks.Do not over tighten.
1.4 Connect the 3/8'' female threads of Hose A to the incoming water adapter. Then screw
the 3/8'' male threads of Hose B to the cold-water line of the kitchen faucet. Again, use
plumber's tape on all male threads and avoid over tightening.
1.5 Hose installation is now complete, butdo not turn on the water supply. Remove both
housings with the housing wrench(included) and proceed to the next steps.