Use and Care Manual
Table Of Contents
- We stand behind our products
- Packing List
- Product Features
- Prior to Installation
- Installation
- Step 1. Install Feed Water Adapter (AFW43)
- It is highly recommended that you watch the video ''How to Install a Feed Water Adapter for Reverse Osmosis (RO) and Other Applications | iSpring AFW43'' on YouTube.
- Turn off the Cold Water Supply Valve (CWSV) under the sink and open the kitchen faucet to release pressure. Prepare a towel or bucket to catch any water drips. Disconnect the kitchen faucet connector pipe from the CWSV.
- Step 2. Install Drinking Water Faucet
- Drill a hole to install the faucet
- Install a faucet bracket (included) instead of drilling a hole (Optional)
- How to Drill a Hole in Sink or Counter-top
- Step 3: Install the System
- Step 4. Tubing Connection
- Install the tubings onto the inlet and outlet of the system. Follow the quick connect instruction to properly connect the system.
- Note: Make sure that water flows in the correct direction from the 1st stage to the 4th stage.
- /
- Step 5. System Start-up
- Make sure no tubing is kinked. Place a towel under the system to catch any possible water leaks.
- Open the drinking water faucet. Slowly turn on the Feed Water Adapter (AFW43) and check for leaks. The top 3 causes of leaks are 1) The tubing is not fully inserted into the quick-connect fitting. 2) The O-ring is not in the correct place or is kinked...
- Rinse the system for 5-15 minutes. It is normal to see residual carbon and fine air bubbles in the water when flushing the system for the first time.
- Check for leaks daily for the first two weeks after installation to ensure the system is functioning properly.
- Maintenance
- Optional Add-on
- Troubleshooting
- Warranty
¡
¡