Install Instructions

2.0 Conditioning the Filter
The filter should now be ready to fill with water. To avoid any problems caused by airlocks in the filter housing, the unit should be
held upside down over the kitchen sink. Partially turn on the cold tap, then pull the valve stem on the diverter valve to allow the
water to gently fill the unit for the first time. Check for leaks. During the first fill, it may take some time for water to appear through
the outlet spout. Once the unit is full, it can be placed upright. Allow the water to run into the sink for a minimum of 10 minutes,
and then stand the filter upright for 24 hours without using it to condition it to the source water. After 24 hours, flush the filter for
another 5 minutes, and then the filter is ready for regular use.