Owner Manual
Table Of Contents
- Prior to Installation
- Installation Steps
- Step 1: Installing the Feed Water Adapter (AFW43)
- Step 2: Installing the RO Faucet
- /How to install an Air-gap Faucet (optional)
- Note: The installation instructions below are for your reference only. An air gap faucet is not included with this system.
- Drill a hole in the kitchen sink or countertop if there isn't already a spare one. Refer to the manual of the faucet when determining the size.
- Place the front plate and the rubber washer on the base of the faucet. Mount the faucet on the countertop.
- From under the sink, connect the RO system pure water output line to the faucet stem. Attach the black drain line from the RO system to the drain input barb. Attach one end of the faucet drain line to the drain output barb and the other end to the dra...
- Step 3: Installing the Drain Saddle
- Step 4: Installing the Vertical Filters: Stages 1, 2, and 3 /
- Step 5: Installing Tank Shut-off Valve (TSV)
- Step 6: Installing the Reverse Osmosis Membrane
- Step 7: Tubing Hook Up (see figure 5 above to see letters not shown below)
- Step 8: System Start-up (model specific sub-steps are marked with a *)
- Section 1: iSpring RO System Maintenance
