Installation Guide

cloth. Once it dries, it may be very difficult to remove and damage the finish. Always follow adhesive manufacturers’

instructions using their suggested adhesive and installation instructions for their adhesive warranty to be in

effect.

NOTE: WE STRONGLY RECOMMEND THE USE OF A MOISTURE BARRIER WHICH IS MANUFACTURED BY

THE ADHESIVE MANUFACTURER, OR IS PART OF THE ADHESIVE (2 in 1). PLEASE CONTACT YOUR LOCAL

DEALER FOR RECOMMENDATIONS.

FOR NAIL/STAPLE INSTALLATION

If you are not a professional flooring installer, you will need to rent a special nailer for hardwood flooring. This tool will

allow you to nail/staple the floor so that they will not show on the finished floor. Be sure to learn how to adjust the

nailer so as not to damage the tongue. Also, be sure that the nailer is designed for or can be adjusted or shimmed

for 14mm flooring. You will need to use 18 gauge 1-1/2" nails/staples for this application, preferably with a 1/4” crown.

Nails/staples should be placed about 6 – 8 inches apart, and not closer than 2 inches from the end of the plank. The

first and last rows will generally need to be nailed by hand next to the wall, as the nailer will not work in these areas.

Pre-drill for 6d finish nails, counter sink, and fill the nail holes with matching putty. Be sure not to place nails too close

to the edge of boards so as to prevent splitting. Generally it is not necessary to use a moisture barrier over wood

subfloors. If you prefer, you can use roofing felt as with any hardwood flooring. Remember to leave at least a minimal

1/2" expansion gap around the perimeter.

NOTE: Splitting of the tongues is a problem normally related to the nailer, not the flooring. If the pressure is adjusted

properly; and the nailer is designed or can be adjusted (shimmed) for a 14mm floor so that the nail/staple is entering in

the proper place, at the proper angle.

FINISHING THE JOB

Inspect your work, as it will cost you more if you have to come back to do a repair later. Replace original

baseboards, or install matching hardwood baseboard. Install matching transitions as needed or recommended

by your dealer or installer. It is not recommended or necessary to seal this floor after installation. Protect

your floor from scratches by using felt pads on chair legs or furniture feet. Plastic rollers/castors can

damage your flooring; if necessary try to replace with softer rubber wheels/castors. When moving

heavy items like refrigerators, use at least two sheets of 1/4" masonite or plywood while moving

(sliding the appliance from one sheet to the next, being careful that they do not move) to protect the

flooring against scratching and denting.

Congratulations! You have just installed an environmentally friendly, beautiful, and elegant bamboo floor!

Rev 121014dz