Owners Manual
Table Of Contents
- Introduction
- Applications
- Product Overview
- Chassis Features and Benefits
- Ordering Data - EZ Series 42
- Performance Data - EZ Series 42
- Ordering Data - EZ Series DR (DR.PTAC)
- Performance Data - EZ Series DR (DR.PTAC)
- Dr. PTAC Features
- Dr.PTAC information
- Dimensional drawings
- Options and Accessories
- Clearances and Projections
- Installation Instructions
- Wall Sleeve Installation Instructions
- Condensate Drain Kit
- Rear Grille Installation Instructions
- Subbase Assembly & Installation
- Chassis Installation
- Front Cover Installation & Removal
- Fresh Air Vent
- Maintenance
- Information for Heat Pump units
- Electrical Installation
- Wiring Diagram
- System Controls and Management
- Digital Control Panel
- Remote Thermostats
- Remote Thermostat Interface
- Control Board
- Temperature Limiting
- Error Codes
- Performance Specifications
- Warranty
Manufacturer of Quality Air Conditioning and Heating Products • www.islandaire.com • sales@islandaire.com • (800)-886-2759
24
Rear Grille Installation Instructions (cont.)
TYPICAL HOLE &
MOUNTING STUD LOCATION
UPPER MOUNTING HOLES
LOCATION & DIMENSIONS
WINDOW FRAME
(LOUVERS NOT SHOWN)
WALL SLEEVE
STUD LOCATION
(CENTER TO CENTER)
CONDENSATE DRAIN LOCATION
LOWER SLOT DIMENSIONS
& LOCATION (TYP.)
.688
.500
.444
.725
.227
.250
.725
.250
.218
.375
.450
.250
1.525 1.525
.079
.725
.9.000
39.750 I.D.
13.887 I.D.
.700
3.150
6.175 14.075 14.075
1.919
.700
1.919
.350
.369
(X2)
.512
.187 (X2)
.400
1.500
.313
Figure 22 Wall Sleeve Dimensions and Mounting Hole Locations for Installation of Exterior Louver Grille by Others