Owners Manual
Table Of Contents
- Introduction
- Applications
- Product Overview
- Chassis Features and Benefits
- Ordering Data - EZ Series 42
- Performance Data - EZ Series 42
- Ordering Data - EZ Series DR (DR.PTAC)
- Performance Data - EZ Series DR (DR.PTAC)
- Dr. PTAC Features
- Dr.PTAC information
- Dimensional drawings
- Options and Accessories
- Clearances and Projections
- Installation Instructions
- Wall Sleeve Installation Instructions
- Condensate Drain Kit
- Rear Grille Installation Instructions
- Subbase Assembly & Installation
- Chassis Installation
- Front Cover Installation & Removal
- Fresh Air Vent
- Maintenance
- Information for Heat Pump units
- Electrical Installation
- Wiring Diagram
- System Controls and Management
- Digital Control Panel
- Remote Thermostats
- Remote Thermostat Interface
- Control Board
- Temperature Limiting
- Error Codes
- Performance Specifications
- Warranty
Manufacturer of Quality Air Conditioning and Heating Products • www.islandaire.com • sales@islandaire.com • (800)-886-2759
20
Condensate Drain Kit
Condensate Drain Kit
Part Number 4090661
An indoor/outdoor drain kit is available as an accessory
item. When a drain kit is to be installed, do so before
installing the wall sleeve in the wall.
During periods of high humidity and/or during heat
pump operation condensate water will collect in the bot-
tom pan of the chassis. When the chassis bottom pan is
full, the water will overow into the wall sleeve and out
the drainage holes on the back edge of the wall sleeve.
e Condensate Drain kit contains an overow tube to
direct excess condensate water from the bottom of the
sleeve to either an internal or external drainage path.
Because heat pumps generate condensate even during
the heating season, it is recommended to always use a
drain kit with heat pump models. Determine whether
the kit should be installed as an internal or external drain
system.
External Drain
Installation
Part Number 6140165
e drain kit can be installed as an external drain on the
le or right side drain opening on the sleeve. Determine
which drain opening will provide the best drainage for
the installation.
Local codes will determine the proper method for con-
densate disposal. e drain kit must be installed before
installation of the wall sleeve condenser grille.
1.
Remove the cardboard weather board from the
wall sleeve.
2. Install the outdoor drain tting and one of the
outdoor drain tting gaskets over one of the
drain holes on the rear of the wall sleeve. Secure
this assembly to the rear of the sleeve with two
sheet metal screws into the holes provided in the
wall sleeve.
3. Cover and seal the remaining drain hole using
the remaining outdoor drain gasket, cover plate
and remaining sheet metal screws provided.
Periodically inspect drain passages for blockage. Blow
out drain tubing annually to prevent overow from
entering the building.
NOTE
is drain kit serves only as a link between the
unit and eld-supplied condensate drain system.
Installing the kit without connecting it to
a drainage system will result in inadequate
condensate removal, possible leakage and
corrosion.
OUTDOOR
GASKET
OUTDOOR
DRAIN
FITTING
SHEET
METAL
SCREWS
Figure 11 External Drain Installation
BLOCK-OFF
PLATE
SHEET
METAL
SCREWS
OUTDOOR
GASKET
INSTALL BLOCK-OFF PLATES
AND GASKETS OVER LEFT AND
RIGHT EXTERIOR DRAIN HOLES
Figure 12 Block-Off Plate Installation