Owners Manual
Table Of Contents
- Introduction
- Applications
- Product Overview
- Chassis Features and Benefits
- Ordering Data - EZ Series 42
- Performance Data - EZ Series 42
- Ordering Data - EZ Series DR (DR.PTAC)
- Performance Data - EZ Series DR (DR.PTAC)
- Dr. PTAC Features
- Dr.PTAC information
- Dimensional drawings
- Options and Accessories
- Clearances and Projections
- Installation Instructions
- Wall Sleeve Installation Instructions
- Condensate Drain Kit
- Rear Grille Installation Instructions
- Subbase Assembly & Installation
- Chassis Installation
- Front Cover Installation & Removal
- Fresh Air Vent
- Maintenance
- Information for Heat Pump units
- Electrical Installation
- Wiring Diagram
- System Controls and Management
- Digital Control Panel
- Remote Thermostats
- Remote Thermostat Interface
- Control Board
- Temperature Limiting
- Error Codes
- Performance Specifications
- Warranty
Manufacturer of Quality Air Conditioning and Heating Products • www.islandaire.com • sales@islandaire.com • (800)-886-2759
14
Dimensional drawings
Units must be installed in accordance with all applicable codes. Ensure that there is adequate clearance for servicing and
proper operation. A minimum of 18 inches in front of the chassis is required. Provide additional space for service techni-
cian to work on the unit. Ensure that drapes, beds, bedspreads, furniture, etc., DO NOT block either return or discharge
air openings.
AUTO
42”
0” min
1” recom-
mended
WALL SLEEVE
FRONT DISCHARGE
GRILLE
3” MIN.
6 1/8”
AIR FLOW
40”
24 5/16”
AIR FLOW
ELECTRICAL KNOCKOUTS
42”
9 9/16”
AIR FLOW
0” min
1” recommended
16”
CORDSET
SUBBASE
Front View
7 7/8”
21 5/8”
13 3/4”
Side View
Top View
Figure 1 Dimensional Drawings