Owners Manual
Table Of Contents
- Introduction
- Applications
- Product Overview
- Chassis Features and Benefits
- Ordering Data - EZ Series 42
- Performance Data - EZ Series 42
- Ordering Data - EZ Series DR (DR.PTAC)
- Performance Data - EZ Series DR (DR.PTAC)
- Dr. PTAC Features
- Dr.PTAC information
- Dimensional drawings
- Options and Accessories
- Clearances and Projections
- Installation Instructions
- Wall Sleeve Installation Instructions
- Condensate Drain Kit
- Rear Grille Installation Instructions
- Subbase Assembly & Installation
- Chassis Installation
- Front Cover Installation & Removal
- Fresh Air Vent
- Maintenance
- Information for Heat Pump units
- Electrical Installation
- Wiring Diagram
- System Controls and Management
- Digital Control Panel
- Remote Thermostats
- Remote Thermostat Interface
- Control Board
- Temperature Limiting
- Error Codes
- Performance Specifications
- Warranty
Manufacturer of Quality Air Conditioning and Heating Products • www.islandaire.com • sales@islandaire.com • (800)-886-2759
12
Dr. PTAC Features
FEATURES:
• Up to 55 CFM Continuous Conditioned fresh air
• Motion sensor/door switch capable
• Superior temperature control
• Dehumidication of room air
• Modern and elegant appearance
• Washable lter for easy cleaning
• User friendly control panel
• Hand held remote controller
• Wired wall thermostat capable
• Compressor freeze protection
• Self diagnosis
• Random Auto Re-Start
• Compressor time delay
• Front desk control
• Room side freeze protection
OPTIONS:
• Two-stage electric heat
• Electric heat add-on for the DR.PTAC fresh air
system for cold climates
ACCESSORIES:
• Condensate removal kit
• 18 gauge insulated wall sleeve
• Wired remote thermostat
• Wireless remote thermostat
• I.R. motion sensor
• Door Switch
• Subbase kit
• Electrical subbase kit
• Duct kit
• Locking control cover
LEED POINTS ACHIEVED:
1. Energy Ecient Design and compliance with
ASHRAE 62.1 and ASHRAE 90.1
2. Indoor Environmental Quality with improved IAQ
through make up air.
3. Innovation in Design through the use of a “Make Up
Air PTAC”.
4. Regional Design through the use of Dr. PTAC in
high humidity climates.
5. Diverting Construction Debris through the use of
re-usable containers.
6. Recycling/reusing Dr. PTAC in secondary market
where the “rst costs” are prohibitive to owners.










