Owners Manual
Table Of Contents
- Introduction
- Applications
- Product Overview
- Chassis Features and Benefits
- Ordering Data - EZ Series 42
- Performance Data - EZ Series 42
- Ordering Data - EZ Series DR (DR.PTAC)
- Performance Data - EZ Series DR (DR.PTAC)
- Dr. PTAC Features
- Dr.PTAC information
- Dimensional drawings
- Options and Accessories
- Clearances and Projections
- Installation Instructions
- Wall Sleeve Installation Instructions
- Condensate Drain Kit
- Rear Grille Installation Instructions
- Subbase Assembly & Installation
- Chassis Installation
- Front Cover Installation & Removal
- Fresh Air Vent
- Maintenance
- Information for Heat Pump units
- Electrical Installation
- Wiring Diagram
- System Controls and Management
- Digital Control Panel
- Remote Thermostats
- Remote Thermostat Interface
- Control Board
- Temperature Limiting
- Error Codes
- Performance Specifications
- Warranty
Manufacturer of Quality Air Conditioning and Heating Products • www.islandaire.com • sales@islandaire.com • (800)-886-2759
29
Front Cover Installation & Removal
Use the following procedure to install the front panel
onto the chassis:
1. Attach the top of the front cover onto the top edge of
the chassis.
2. Swing down the front cover over the chassis and
apply pressure until it locks into place.
3. Make sure that digital display opening and lters
align with proper locations on chassis.
Front Cover Removal
Remove the front cover by pulling out at the bottom to
release it, then li it up to clear the rail along the chassis
top.
TABS
Figure 29 Front Cover Tabs
Figure 30 Front Cover Installation
Figure 31 Front Cover Installation