- Peripheral Automobile Accessories User Manual

11. Warranty

One Year Limited Warranty

The quality controls used in the manufacture of this product will ensure your satisfaction.

This warranty applies only to the original purchaser of this product from an authorized

iSimple

dealer. This warranty covers any supplied or manufactured parts of this prod-

uct that, upon inspection by iSimple

authorized personnel, is found to have failed in

normal use due to defects in material or workmanship. This warranty does not apply to

installation expenses. Attempting to service or modify this unit, operating this unit under

conditions other than the recommended voltage will render this WARRANTY VOID.

Unless otherwise prescribed by law, iSimple

shall not be liable for any personal injury,

property damage and or any incidental or consequential damages of any kind (includ-

ing water damage) resulting from malfunctions, defects, misuse, improper installation or

alteration of this product. All parts of this iSimple

product are guaranteed for a period

of 1 year as follows:

Within the rst 12 months from date of purchase, subject to the conditions above,

iSimple

will repair or replace the product at their discretion, if it is defective in material

or workmanship providing it is returned to an Authorized iSimple

dealer, with PROOF

OF PURCHASE from an authorized iSimple

dealer.

Warning:

This equipment may be reset by unintentional electrostatic discharge during operation.

Exposure to direct sunlight or extreme heat may cause damage or malfunction.

FCC Class B Radio Frequency

Interference Statement

This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of FCC rules. These limits are designed to

provide reasonable protection against harmful interference in a residential instal-

lation. This equipment generates, uses, and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be deter-

mined by turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

1. Re-orientate or relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from

that of which the receiver is connected.

4. Consult the dealer or an experienced radio / television technical for help.

Notice : The changes or modications not expressly approved by the party responsible

for compliance could void the user authority to operate the equipment.