User's Manual

5
product which states: “Contains transmitter module F CC ID: 2AI2V-ISBLE1810X52L”, Additionally,
the following statement should be included on the label and in the final product’s user manual:
“This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interferences, and (2) this device must accept
any interference received, including interference that may cause undesired operation.” 
This module has been granted modular approval for mobile applications. OEM integrators for host
products may use the module in their final products without additional FCC certification if they
meet the following conditions. Otherwise, additional FCC approvals must be obtained.
 The host product with the module installed must be evaluated for simultaneous transmission
requirements.
 The users manual for the host product must clearly indicate the operating requirements and
conditions that must be observed to ensure compliance with current FCC RF exposure
guidelines.
 OEM integrator /End product manufacturer must perform the test of radiated & conducted
emission and spurious emission, etc. according to FCC part 15C : 15.247 and 15.209 &
15.207 ,15B Class B requirement, Only if the test result comply with FCC part 15C : 15.247 and
15.209 & 15.207 ,15B Class B requirement, then the end product can be sold legally
 The final host / module combination may also need to be evaluated against the FCC Part 15B
criteria for unintentional radiators in order to be properly authorized for operation as a Part
15 digital device.
 This Module is full modular approval, it is limited to OEM installation ONLY. 
 The module is limited to installation in mobile application. 
 A separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and difference antenna configurations. 
 The OEM integrator is responsible for ensuring that the end-user has no manual instruction
to remove or install module. 
 The Grantee will provide guidance to the Host Manufacturer for compliance with the Part 15B
requirements if requested.
 To comply with FCC regulations limiting both maximum RF output power and human
exposure to RF radiation, the maximum antenna gain including cable loss in a mobile-only
exposure condition must not exceed below table.
Fixed Print Antenna , 0 +/- 0.5 dBi
Ipex type detachable PIFA Antenna , 2.0 +/- 0.5 dBi
Ipex type detachable PCB Antenna , 2.0 +/- 0.5 dBi
Ipex type detachable Dipole Antenna , 4.5 +/- 0.5 dBi
The antennas above comply with FCC 15.203 requirements.
All type of antenna impedance is 50Ω