Operation Manual

Total number of connection is exceeded.
Disconnect the camera in order to replace the connection
※
ISAW RC can control maximum 9 cameras at the same time
WiFi is connected but signal is unstable.
Check the camera's WiFi signal status
Properly disconnect WiFi connection from the camera
DescriptionStatus Image
* Exceeded connection
* Unstable connection
*Disonnection failed
Currently connected to the camera
Press 'MODE and CAMERA' buttons together for 2 seconds.
RC starts to disconnect from the camera.
RC is now disconnected from the camera.
RC is back to standby mode.
If there is other connected camera to the RC, it will automatically
connect to other camera.
(Camera #2 is disconnected, and RC is now connected to camera #3)
WiFi disconnection is failed.
Press 'YES' button to retry the disconnection.
Description
Status Image
Step#1. Connected
Step#2. Disconnect
Step#3. Disconnected
Step#4. Standby
Step#5.
Connect Other Cam
5. General operations
6. LCD Screen
Video mode or Photo mode
Shows currently connected camera status
Camera LCD
Mode
WiFi signal status
WiFi
SD card connectivity
SD card
Balance memory capacity of SD card
Memory
Battery status of currently connected camera
Cam battery
Ready or Recording
Recording
Shows recording mode or photo setup mode
Rec. mode
Video / Photo resolution
Resolution
Image quality of video / photo
Quality
Shows remote status in LCD
Remote LCD
Currently connected camera's number
Current Cam
Total number of camera connected
Total Cam
All: Control all connected cameras simultaneously
One: Control individual camera currently connected
Device
Battery status of remote controller
RC battery