Wood Slat and Metal Platform Bed Frame with Solid Wood Headboard INSTRUCTION GUIDE
WARNING WARNING! ¡ADVERTENCIA! ATTENTION! • Keep small parts out of reach of children. • Make sure the bed frame’s legs remain in contact with the ground. • Do not use this product if parts are missing, damaged, or worn. • Do not stand on the product. • Clean with a sponge and warm soapy water. • Never use abrasives or chemicals to clean. • Do not use solvent-based cleaners or detergents as they can bleach or damage the product. • For wood beds, vacuum or brush with a soft brush on a regular basis.
PARTS Headboard Headboard Legs Footboard Legs Footboard Center Rail Front Rail Sideboard Center Leg Slats Screw Center Screw Allen Wrench 3
ASSEMBLY INSTRUCTIONS STEP 1 K I K A B FRONT HEADBOARD ASSEMBLY: Lay headboard legs (A & B) flat on floor. Screw the front rail (I) into the holes in the side of the headboard. E K Attach the headboard (E) to the back of the bed using 6 screws. If possible, get 4 someone to help you with this step.
ASSEMBLY INSTRUCTIONS STEP 2 F D C REAR FOOTBOARD ASSEMBLY: Lay footboard (F) flat on floor. Screw the footboard legs (D & C) into the holes in the side of the footboard using the 2 screws in each side.
ASSEMBLY INSTRUCTIONS STEP 3 K B A G G D C ASSEMBLE THE SIDEBOARDS: Attach the sideboard (G) to the front headboard assembly and rear footboard assembly to the on all four sides as shown. Flanges on the sideboard should face inward and velcro should face upwards.
ASSEMBLY INSTRUCTIONS STEP 4 L H H J K ASSEMBLE THE CENTER RAIL: Attach the center leg (F) to the center rail (E) using the center screw Lift the center rail (H) and push down to lock into place on the headboard and footboard. Tighten the pre-assembled screws to secure into place to the footboard. STEP 5 ATTACH THE SLATS: Attach to the frame by laying slats on the velcro on the side rails.
BED SAFETY GUIDE HEADBOARD WARNING! The Entrapment distance cannot be greater than 3-Inches. Entrapment Distance is the gap between the highest point of the Mattress and the lowest point of the Headboard. Mattress should be sized accordingly. MATTRESS ¡ADVERTENCIA! La distancia de atrapamiento no puede ser superior a 3 pulgadas. La distancia de atrapamiento es la brecha entre el punto más alto del colchón y el punto más bajo de la cabecera. El colchón debe tener el tamaño adecuado.
