ASSEMBLY INSTRUCTION TWIN TWIN BUNK BED Post I}] Post C Guardrail m Guardrail 7 7 PCS PCS 1PC PCS F Guardrail Upper Rear Rail Upper Front Rail Guardrail 1PC 1PC 1PC 1PC [I Guardrail Lower Rail Slat Slat Connector % <& 1PC PCS 44PCS 88PCS w Ladder m Slat Spacer m Bolt E Bolt <5 1PC PCS PCS PCS @ Bolt IE Bolt Washer Nut 1/4" < PCS PCS PCS 1PC L-Allen Key V Wrench 4mm 5/16" 1/4" This page lists all the contents included in the box.
1 Attach Guardrail (D) into the Post (A) and Post (B), insert the Bolt (O) and the Washer (S), turn the L-Allen Key (U) to tighten them. 3 Attach the Guardrail (D) into the Post (A) and Post (B), insert the Bolt (O) and the Washer (S), turn the L-Allen Key (U) to tighten them.
Insert the Guardrail (1) into the Post (A) and Post (B). turn the L-Allen Key (U) to tighten them. Attach the Upper Front Rail (H) and Upper Rear Rail (G) to the Posts (A) and (B), Guardrails (C) and (I), insert the Bolt (P) and turn the L-Allen Key (U) to tighten them.
Attach the Guardrail (F) and Guardrail (E) to Upper Front Rail (H) and Upper Rear Rail (G), insert the Bolt (Q) and the Nut (T), turn the L-Allen Key (U) and the Wrench (V) to tighten them. And insert the Bolt (R), turn the L-Allen Key (U) to tighten them. Insert the Slat Connector (L) to the both sides of Slat (K), press the Slat (K) into the correct place. Attach the assembled Slats (K) to the upper and lower rails, insert the Slat Connector (L) into the correct holes.
Make the Slat Spacer (N) to connect two slats as below instruction. Attach the Ladder (M) to the Upper Front Rail (H), insert the Bolt (Q), turn the L-Allen Key (U) to tighten them. Cleaning & Care Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surfaces with a dry or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over time. Periodically check that all connections are tight.
