User Guide

The message “FUS” and the malfunctioning station number will be

displayed if a short circuit is detected. The station will be bypassed

during the watering cycle enabling the remaining stations in the

watering cycles to run. The FUS display will alternate with the

current time display.

IMPORTANT: Determine the cause of the problem and take

corrective action as necessary.

With the Dial set in the Current Time position, press any button to

clear the “FUS” display.

The Clear Program memory feature enables any Program to

be quickly erased when removal or reprogramming is desired. The

memory erase function applies only to the specified Program; leaving

all remaining Program setup information intact.

IMPORTANT: The Clear Program process completely erases

all operating information from the selected Program (no start

times, run times or active days).

Note: To return the Program back to factory default settings, refer

“Factory Default Reset Feature” on page 29.

1. Place the Function switch in the Set Programs position.

2. Place the Program switch to select A, B or C.

3. Turn the Dial to the Skip Days/ Special Functions position.

4. Press the Manual button three times (from the initial Skip

Days screen) to display CLr (Clear).

5. Press the button one time. The display will show the prompt:

CL? (Clear?).

6. To complete the clearing process, press the button again.

The display will show End to signify program memory is cleared.

Clear Program Memory Feature

Diagnostic Circuit Breaker Feature

66767_RainDial 0428A 3/28/07 2:25 PM Page 28