User Guide

This feature enables the MV/Pump circuit to be automatically turned
On and Off by specific station as needed, where only certain sta-
tions require a booster pump to increase system pressure. The
default setting is pump On (P:ON) for all stations.
Note: Applies to the station regardless of it’s Program assignment.
1. Place the Function switch in the Set Programs position.
2. Turn the Dial to the desired station number (station run time will
be displayed).
3. Press the Manual button: P:ON (Pump On) will be displayed.
4. Press button to select P:OF (Pump Off). Press the button
to reselect P:On.
5. Turn the Dial to the Current Time position.
6. Place the Function switch in the Run position.
The Well Recovery Delay feature enables an adjustable delay
period, ranging from 1 second to 2 hours, to be entered between
consecutive stations during a watering cycle to compensate for
well/cistern recovery time or slow-closing valves.
1. Place the Function switch in the Set Programs position.
2. Place the Program switch to select A, B or C.
3. Turn the Dial to the Skip Days/ Special Functions position.
4. Press the Manual button 4 times (from the initial Skip Days
screen) to display W:00 (no delay).
5. Use the and buttons to set the desired time: 0–59 seconds,
1–59 minutes or 1.0–2.0 hours.
Note: Hold the button down to scroll. The display will continuously
scroll from seconds to minutes to hours (:00 = no delay).
6. Turn the Dial to the Current Time position.
7. Place the Function switch in the Run position.
Well Recovery Delay Feature
MV/Pump Control per Station Feature
26
66767_RainDial 0428A 3/28/07 2:25 PM Page 26