User Guide

Indoor Models
1. Route the plug-in transformer cable through the small hole
provided in the bottom of the cabinet.
2. Tie a knot in the cable to provide a strain relief, and connect the
wires to the terminals labeled “24 VAC” (in either order).
3. Close the control module and plug the transformer into a wall outlet.
The controller is now ready to program and operate.
Note: To immediately test-run the Rain Dial irrigation control
system, refer to the “Station Test Run Feature” on page 15.
EARTH
GROUND
MV/
PUMP
789101112
123456
24 VAC
VC
Connecting the Power Source
13
24 VAC, 30VA
Transformer
Figure 6
66767_RainDial 0428A 3/28/07 2:24 PM Page 13