User Guide

6. Connect the Valve Common wire to the terminal labeled “VC.”
7.
Connect the master valve or pump start relay control wire
(if applicable) to the terminal labeled “MV/PUMP.”
Note: The controller does not supply power to operate the pump.
The pump start relay or master valve must have a nominal coil
voltage of 24 VAC at 0.375A.
11
Figure 4
Sprinkler Control Valves
(0.5A max. per Station)
Valve Common Wire
to Terminal “VC”
Master Valve or Pump Start Relay
66767_RainDial 0428A 3/28/07 2:24 PM Page 11