User manual

24
Remote Sensor Status
The wave icon above the current channel display shows the connection status of the
corresponding remote sensor:
Icon Status
Searching for remote sensor signals
Corresponding remote sensor successfully linked
No signals received for more than 15 minutes
Activating Main Console Unit to Search for All Remote Sensor Signals
The main console unit may be manually activated to search for signals from all remote
sensors.
Press and hold DOWN to enforce a search.
Rain Mode
The main console unit records the total amount of rainfall for the last hour, last 24 hours,
yesterday, last week and last month. The rainfall may be displayed in mm or inches.
A daily rainfall alert function is available which can be programmed to sound if the daily
rainfallexceedsapre-conguredlimit.
Accessing Rain Mode
From the main console unit: Press UP or DOWN until the RAIN icon on the display
startsashing.
From the remote control: Press .
Viewing Rain Statistics
In Rain Mode, each press of SET or MEM or MEMORY rotates display between different
rain statistics:
- Last hour
- Last 24 hour
- Yesterday
- Last week
- Last month
Tip: For an estimation of the rain rate, the Last Hour rainfall value can be understood as
“inch/hr” or “mm/hr”.
Resetting the Rainfall Statistics Memory
In Rain Mode, press and hold MEM or MEMORY to reset all rainfall statistics.
Setting Units for Rain Display (inch or mm)
In Rain Mode, press and hold SET to convert units between mm and inches.
Activating/Deactivating the Daily Rainfall Alert
1. In Rain Mode, each press of ALARM rotates display between the current rainfall
statistics and the daily rainfall alert (“ALARM HI” will be displayed).
If the alert is deactivated, “OFF” will be shown, otherwise the rainfall alert value is shown.
2. When the rainfall alert is displayed, pressing UP or DOWN will activate/deactivate it.