User manual

22
Understanding the Sunrise/Sunset Display
The sunrise time being displayed differs during the morning and the afternoon/night.
From 12 am to 12 pm: The sunrise time for the current day will be displayed.
From 12 pm to pm: The sunrise time for the next day will be displayed.
“NEXT DAY” icon will be displayed above the sunrise time.
At certain locations (especially those at high latitudes), sunrise and sunset events may not
occur within a 24 hour time frame.
Display Sunset status Display Sunset status
FULL Sunrise at FULL Sunset at
previous day later next day or
---- No sunrise for ----- No sunset for the
the whole day whole day
Temperature and Humidity Mode
The weather station supports up to 5 remote thermo-hygro sensors, each sensor cor-
responding to a separate channel for the temperature and relative humidity display. The
temperature may be shown in degrees Celsius ºC or degrees Fahrenheit ºF. The trend
(rising, steady or falling) of all values is also indicated on the display.
The main console unit uses the indoor temperature and humidity data to compute a
comfort level rating of Wet, Comfort or Dry.
A temperature alert function is available for each channel. It can be programmed to sound
ifthechanneltemperatureexceedsorfallsbelowthepre-conguredupperandlower
limits.
Note: The temperature alerts have a 0.5 ºC hysteresis to prevent the alerts from sounding
constantlyduetosmalluctuationsnearthealertvalue.Thismeansthatafterthetempera-
ture reaches the alert value, it will have to fall below the alert value plus the hysteresis to
deactivate the alert.
Accessing Temperature and Humidity Mode
From the main console unit: Press UP or DOWN until the IN icon on the upper right
ofthedisplaystartsashing.
From the remote control: Press .
Viewing Temperature and Humidity Display for each Channel
For Static Display:
In Temperature and Humidity Mode, each press of CHANNEL rotates display between
different channels.
For Cycling Display:
To enable automatic rotating between different channel displays, press and hold
CHANNEL, until the II icon is displayed. Each valid channel will now be alternately
displayed for 5s.