Operation Manual
– Press S3 to show Pulse mode, mode prompt “PULS” will be displayed for
1 second first.
– Heart icon flashes when heart rate signal is received from the transmitter
and the heart rate is shown at the middle row of the display.
– If zone alarm is set to “on”, 1 “Beep” sound will be given every 6 seconds
when heart rate is below “Zone Low Limit” and 2 “Beep” sounds will be
given every 6 seconds when heart rate is above “Zone High Limit”. And
the displays will be as follow:
Remarks
1. If no heart rate signal is received for 1 minute, the link between the watch
and the transmitter will be cut off automatically, and “---” (not flashing)
will be shown at the middle row of the display. To re-link, press S1, and
“---” will start flashing or heart rate will be shown.
2. If zone alarm is set to “off”, there will be no zone alarm or high/low limit
indication.
%(/2:³=21(/2:/,0,7´ $%29(³=21(+,*+/,0,7´
5HR?ENPDF5HR
59
2245_Bedienung_EN 25.5.2005 09:45 Uhr Seite 59