Instruction manual

60 • Thermo Peer
10.1 PUTTING THE THERMO PEER INTO OPERATION
1. The Thermo Peer is supplied with a battery already inserted and is in a
battery-saving slumber mode. The display is switched off, i.e. ‘empty’ in this state.
2. The Thermo Peer is activated by pressing any key for at least 5 seconds.
3. The peer can now be operated as described below.
! Important note:
The Thermo Peer is a high-quality measurement device with many functions that
you can infl uence. A few functions that run in the background (e.g. the clock),
however, cannot be infl uenced. Please be aware that the active use of each
additional function uses electricity and thus the battery. If you have activated the
active transfer permanently, the battery output will also be used by this and this
has a direct infl uence on the life of the battery.
If you are going on an expedition where you will make intensive use of the Ther-
mo Peer and you and your equipment will be exposed to very cold temperatu-
res, we strongly recommend that you take replacement batteries (type CR2032)
with you.
The Thermo Peer as a simple watch has a life of up to one year. The repeated
use of many functions can reduce the battery life to just a few weeks!