Instruction manual
ENG
53
WIRELESS REMOTE SENSOR REGISTRATION
PROCEDURE
1. Insert x4 AA batteries rst to the main unit, the temperature display shows
- - . – While the wave icon will keep blinking for 2 minutes indicate unit is
in sensor searching mode.
2. In a second step, insert the x2 AAA batteries for the sensor unit. The LED
on the front panel will start ashing at a rate of one time per around 2
seconds indicates channel-1 is in use.
3. While the LED is ashing, press once the [CH] key will change the sensor
channel setting to 2. Keep toggle on [CH] key can change channel setting
up to 3. The LED is blinking at a frequency to indicate the channel setting.
i.e. continuous blinks 2 times indicate channel-2 is selected.
Note:
If user does not press any key for 10 seconds, it will exit the channel setting
mode and transmit the RF signal. The main unit will register the temperature
reading.
(If the transmitter has the LCD display, the C/F key will toggle the temperature
unit on the LCD.)
REMOTE CHANNEL AUTO-SCROLLING
This device is equipped with an auto-scroll function. While the auto-scroll
function is set, the unit will automatically cycle to display the temperature of
each remote sensor for 6 seconds.
1. To retrieve manually the specic sensor temperature reading, press
CHANNEL key until desired channel number is displayed.
2. To enable auto-scroll function, use CHANNEL button to select channel 1,
2, ... until auto scroll is enabled.