Product Manual

Page 6 of 14
• Do not overreach. Keep proper footing and balance at all times.
• Remove keys or wrenches before connecting the tool to an air supply, power supply, or turning on
the tool. A wrench or key that is left attached to a rotating part of the tool may cause personal
injury.
• Secure the work with clamps or a vise instead of your hand when practical. This safety precaution
allows for proper tool operation using both hands.
⚠CAUTION
WELDING HELMET USE AND CARE
• Do not force the welding helmet. Products are safer and do a better job when used in the manner
for which they are designed. Plan your work and use the correct product for the job.
• Check for damaged parts before each use. Carefully check that the product will operate properly
and perform its intended function. Replace damaged or worn parts immediately. Never operate the
product with a damaged part.
• Do not use a product with a malfunctioning switch. Any power tool that cannot be controlled with
the power switch is dangerous and must be repaired by an authorized service representative
before using.
• Disconnect the power/air supply from the product and place the switch in the locked or off position
before making any adjustments, changing accessories, or storing the tool. Such preventive safety
measures reduce the risk of starting the tool accidentally.
• Store the product when it is not in use. Store it in a dry, secure place out of the reach of children.
Inspect the tool for good working condition prior to storage and before re-use.
• Use only accessories that are recommended by the manufacturer for use with your product.
Accessories that may be suitable for one product may create a risk of injury when used with
another tool. Never use an accessory that has a lower operating speed or operating pressure than
the tool itself.
• Keep guards in place and in working order. Never operate the product without the guards in place.
• Do not leave the tool running unattended.
Specific Operation Warnings
⚠WARNING
• To prevent serious injury or property damage, read and understand owner’s manual before
operating.
• Before welding or cutting, ensure the darkness range of this helmet offers enough eye protection
for your use.
• Always wear ANSI Z87.1 compliant eye protection along with the welding helmet during use. The
front cover lens (front impact resistant plate) CAN BREAK and DOES NOT provide complete
protection against flying particles, splash, spray and splatter.