Product Manual
Page 9 of 12
Failure
Possible Cause
Corrective Action
Switch is in the wrong position.
Move the switch to the AUTO position.
Rechargeable batteries are at the end
of their life.
Replace the batteries with new
rechargeable batteries of the same
type and size.
Battery Replacement
1. Batteries are located in the battery
housing located at the back of the
lamp.
2. Remove screws from front of the
battery housing to access
batteries.
3. Replace batteries with
rechargeable batteries of the
same type and rating.
4. Reassemble the battery housing.
Sensor is malfunctioning.
Resetting the Sensor:
1. Take the light into a dark room and
then switch to the Auto.
2. Activate the motion sensor in the
dark.
3. Once the light turns on, the
sensors are reset.
4. Wait until the light turns off before
returning the product to a lit room
or area.
Light does not
stay on as long
as it previously
did or it flashes.
Batteries are not fully charged.
Ensure the solar panel is in a location
where it will receive maximum sunlight
during daytime hours.
Turn the light to the OFF position and
allow the solar panel to charge the
batteries for two sunny days.
Solar panel is not receiving enough
sunlight and not able to recharge
batteries.
Clean the solar panel with a clean,
damp cloth.
It is winter and there is not as much
sunlight as during summer. The solar
panel is not able to recharge the
batteries.
Ensure the solar panel is located in a
place where it will receive the
maximum amount of sunlight during
the day. Remove any object that
throws shade on the solar panel. Tilt
the solar panel so that it is
perpendicular to the sun.