Product Manual
Page 6 of 12
Make sure this is clear of obstacles such as cables and electric lines.
Secure lamp to the wall with screws provided.
Carefully route the wire from the solar panel to the lamp and plug it into the battery
housing input.
Adjust the motion sensor so that it faces the area where motion detection is desired. You
can move it up and down by adjusting the screw on the neck of the motion detector.
Note: The lamp unit should be mounted 6.5-9 feet (2-3 meters) from the ground to ensure motion
detection is optimized
2. Wall or Deck Mounting
Secure the bracket to the solar panel with the screw provided, as shown below.
Set the bracket on the surface and secure it in place with the larger screws provided.
Adjust the angle of the solar panel to ensure it receives optimum sunlight.
Note: The light is equipped with a specific length of wire. Ensure that the wire will reach the desired
position of the lamp before making the final installation.
Before Each Use
⚠WARNING
Solar lights require sunlight to function properly. Extended periods of cloudy weather will cause
shorter runtimes. Shade on the solar panel is to be avoided. The solar panel may be cleaned with a
clean, damp cloth. Do not use soap, solvents, or abrasives.