Product Manual

Page 11 of 15
 Insert the light bulb (not included) into the socket.
 Close the light guard.
After Each Use
⚠WARNING
 Unplug and allow to cool before replacing bulb. Bulb gets HOT quickly! Only contact On/Off
Button/Plug when turning on. Do not touch hot lens, guard, or enclosure. Do not remain close to
the light if skin feels warm. Do not look directly at lighted lamp.
 Do not touch the bulb with bare hands. Oil from skin will drastically shorten the life span of the
bulb if not cleaned with rubbing alcohol and allowed to dry before use.
 Handle the bulb with a soft, clean cloth or clean work gloves.
Allow light set to cool and then wipe external surfaces with a clean cloth.
Maintenance
⚠WARNING
 If the supply cord of this light is damaged, it must be replaced only by a qualified service
technician.
 Procedures not specifically explained in this manual must be performed only by a qualified technician.
Maintain the product by adopting a program of conscientious repair and maintenance in accordance
with the following recommended procedures. It is recommended that the general condition of any tool
be examined before it is used. Keep your tool in good repair. Keep handles dry, clean, and free from
oil and grease. The following chart is based on a normal operation schedule.
TO PREVENT SERIOUS INJURY FROM LIGHT FAILURE: Do not use damaged equipment. If
damage is noted, have the problem corrected before further use.
Maintenance Interval
Maintenance Point