3-Drum Rack Owner’s Manual WARNING: Read carefully and understand all ASSEMBLY AND OPERATION INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury.
Thank you very much for choosing an Ironton™ product! For future reference, please complete the owner’s record below: Serial Number/Lot Date Code: ________________________________ Purchase Date: ____________________________________________ Save the receipt, warranty, and this manual. It is important that you read the entire manual to become familiar with this product before you begin using it. This drum rack is designed for certain applications only.
Table of Contents Intended Use .......................................................................................................................................... 4 Packaging Contents .............................................................................................................................. 4 Technical Specifications ...................................................................................................................... 4 Important Safety Information .................
Intended Use The Ironton 3-Drum Rack is designed for stacking steel drums horizontally. The all steel construction can be safely stacked four units high. The rack has a welded and bolted assembly with hardware included. Packaging Contents Part A (17) Side Rack (2) Connecting Pipe (3) Bolt Set (nut, washer) (12) Technical Specifications Property Material Fits Drum Size (gallon) Capacity (lb.
⚠WARNING WORK AREA SAFETY Inspect the work area before each use. Keep work area clean, dry, free of clutter, and well-lit. Cluttered, wet, or dark work areas can result in injury. Using the product in confined work areas may put you dangerously close to cutting tools and rotating parts. Keep children and bystanders away from the work area while operating the tool. Do not allow children to handle the product.
Specific Operation Warnings ⚠WARNING Do not exceed the rated load capacity. Use on a flat, hard, level surface. Assembly Instructions 1. Connect the two side racks (1) and the three connecting pipes (2) with bolts (5), washers (4), and nuts (3). 2. Tighten all bolts. The location of each part is shown in the following illustration. Operating Instructions Place the drums on the rack.
Maintenance Maintain the product by adopting a program of conscientious repair and maintenance in accordance with the following recommended procedures. It is recommended that the general condition of any tool be examined before it is used. Keep your tool in good repair. Keep handles dry, clean, and free from oil and grease. The following chart is based on a normal operation schedule. Maintenance Interval Maintenance Point After daily use Clean the product with a dry, soft cloth.
Limited Warranty Northern Tool and Equipment Company, Inc. ("We'' or ''Us'') warrants to the original purchaser only (''You'' or ''Your'') that the Ironton product purchased will be free from material defects in both materials and workmanship, normal wear and tear excepted, for a period of one year from date of purchase. The foregoing warranty is valid only if the installation and use of the product is strictly in accordance with product instructions.
Distributed by: Northern Tool & Equipment Company, Inc. Burnsville, Minnesota 55306 www.northerntool.
