Product Manual

Page 6 of 10
⚠CAUTION
CAMERA USE AND CARE
 Do not force the camera. Products are safer and do a better job when used in the manner for
which they are designed. Plan your work, and use the correct product for the job.
 Check for damaged parts before each use. Carefully check that the camera will operate properly
and perform its intended function. Replace damaged or worn parts immediately. Never operate the
camera with a damaged part.
 Do not use a camera with a malfunctioning switch. Any power tool that cannot be controlled with
the power switch is dangerous and must be repaired by an authorized service representative
before using.
 Store the camera when it is not in use. Store it in a dry, secure place out of the reach of children.
Inspect the tool for good working condition prior to storage and before re-use.
 Use only accessories that are recommended by the manufacturer for use with your camera.
Accessories that may be suitable for one product may create a risk of injury when used with
another tool. Never use an accessory that has a lower operating speed or operating pressure than
the tool itself.
 Keep guards in place and in working order. Never operate the product without the guards in place.
Operating Instructions
⚠WARNING
 Do not use in wet locations. If using outdoors, position the camera in a sheltered area.
 Select a location for the camera that is easily visible by potential intruders, but out of reach.
 Point the camera and LED towards the area of concern so that the flashing light is easily visible.
Operating the Camera
 Choose a location for the camera.
 Loosen the knob on the bracket to move the camera to the position required; tighten the knobs to
position the camera in place.
 Mount the camera to the wall using screws.
 Position camera front with flashing LED so it’s easily visible.
 Two ways to power the camera:
1. solar (in well-lit areas or during the day)
2. two AAA batteries (in low-light conditions or at night)