Product Manual

Distributed by:
Northern Tool & Equipment Company, Inc.
Burnsville, Minnesota 55306
www.northerntool.com
5-DRAWER STEEL TOOL BOX INSTRUCTIONS
MOUNTING INSTRUCTION
For Customer Service or Warranty Information: 1-800-222-5831
Truck Bed
NOTE:
If your truck has a bed liner, use these instructions
as a guide only. Due to the many dierences in bed liner
thickness and t, longer attaching devices are recommended.
You will need to insure that your truck box is mounted
securely to the truck, not the bed liner.
5 Drawer
Tool Box
Secure Bottom Tray
to Truck Bed
Open the front door and remove the bottom drawer to access the
locking tab on the body oor. This tab will allow you to release the
mounting tray from the tool.
While pressing the 2 latch posts on the inside of the box together, push
the bottom tray towards the back of the box. This will result in the
separation of the mounting tray from the main body housing, leaving 2
separate parts.
Position the mounting tray behind the fender are of your choice,
ensuring that the front faces the tailgate.
When you have the mounting tray in the desired position, it is recom-
mended to mark the holes prior to drilling, in case shifting of the
mounting tray occurs during drilling.
Using a 3/8” drill bit, drill through the bed exterior on your markings.
Thoroughly clean the surface location where the tool box will be
mounted, then line up the drill holes to the mounting tray.
1.
2.
3.
4.
5.
6.
Using the bolts supplied, begin inserting them through the
mounting tray into the drilled holes. Rotate all screws
before tightening any screw completely. As the screws become
tighter, completely fasten them to the frame.
Ensure the undercarriage of the tool box is free of debris, as well
as the mounting tray. Slide the tool box back onto the mounting
tray in a similar fashion as it was removed.
Re-insert any trays that were removed from the tool box during
installation.
Remove the keys from the interior of the box and store them
in a safe location.
7.
8.
9.
10.
Any leaking caused by unsealed holes in the box bottom will
void the warranty.
Read these instructions to familiarize yourself with assembly and installation. This tool box is designed for certain applications only.
Northern Tool & Equipment is not responsible for issues arising from modication or improper use of this product such as an application for
which it was not designed. We strongly recommend that this product not be modied and/or used for any application other than that for
which it was designed.
This tool box must be securely mounted to prevent
movement or shifting.