Manualshelf

Product Manual

ManualsBrandsIronton ManualsCord ReelsRetractable Extension Cord Reel with Worklight — 30ft., 16/3, LED Light
12345678910
Page 8 of 17
Assembly – 49669 & 49670
This cord reel is intended for industrial use and is provided with permanent mounting means. This
equipment should be properly installed before use in accordance with local codes and ordinances.
Only qualified personnel should undertake the installation and commissioning of this product.
Failure to comply with instructions could result in personal injury and/or property damage.
Do not disassemble a spring assembly for any reason! Serious personal injury could result. Reels
are equipped with a spring under tension.
Ceiling Mount with the Flying Ring (Fig. 1)
1. Select a ceiling location within 1 feet of an electrical
outlet.(We suggest the receptacle near your garage door
opener if available).
CAUTION: Check that the power at the outlet conforms to the
rating for the reel (see technical specifications for the reel).
The outlet must be a three-pronged grounded outlet.
2. Locate a ceiling beam (use a stud finder if needed) and install
the Hanger Hook (10 or 13) in the beam.
CAUTION: Drywall alone will not hold the weight of the reel.
Note: the reel can be installed by the mounting bracket is the
same way as a wall mount. See the steps in the wall mount
section below.
3. Hang the reel on the hook using the flying ring.
4. Use a pair of pliers to close the hook so the reel is secure and won’t slide off.
5. Adjust the cord stop so the work light hangs at a desired length when cord is retracted.
6. Plug the lead-in cord into the outlet.
Wall Mount with the Mounting Bracket (Fig. 2)
1. Select location within 2 feet of an electrical outlet.
CAUTION: Check that the power at the outlet conforms to the
rating for the reel (see technical specifications for the reel).
The outlet must be a three-pronged grounded outlet.
2. Locate a wall beam (use a stud finder if needed).
CAUTION: Drywall alone will not hold the weight of the reel.
3. Attach the U-shaped bracket (A) to the beam with the screws
provided.
4. Place the hanger bracket (2, B) inside the U-shaped bracket
(see Fig 2), lining up small holes in the two brackets.
5. Insert the locking pin (C) through aligned holes.
6. Adjust the cord stop so the work light hangs at desired length
when cord is fully retracted.
7. Plug the lead-in cord into the outlet.