Product Manual

Page 7 of 17
Assembly – 49667
 This cord reel is intended for industrial use and is provided with permanent mounting means. This
equipment should be properly installed before use in accordance with local codes and ordinances.
 Only qualified personnel should undertake the installation and commissioning of this product.
Failure to comply with instructions could result in personal injury and/or property damage.
1. Select an indoor wall or ceiling location within 4 feet of an electrical outlet.
⚠CAUTION
 Check that the power at the outlet conforms to the rating for the reel (see technical specifications
for the reel).
 The outlet must be a three-pronged grounded outlet.
2. Locate a wall or ceiling beam (use a stud finder, if needed) and using the mounting bracket as a
template, mark the holes so they are centered on the beam.
⚠CAUTION
Drywall alone will not hold the weight of the reel.
3. Attach the mounting bracket to the beam using cement screws or wood screws.
4. Adjust the cord stopper to the suitable position when required.
5. Open the light cage, install an E26 bulb (MAX: 75W), then close and latch the cage.
6. Plug the lead-in cord into the outlet.
 Do not disassemble a spring assembly for any reason! Serious personal injury could result. Reels
are equipped with a spring under tension.