Product Manual

Page 8 of 16
Assembly - 49668
Ceiling Mount with the Flying Ring (Fig. 1)
1. Select an indoor ceiling location within 1 foot of an electrical
outlet (We suggest the receptacle near your garage door
opener if available).
CAUTION: Check that the power at the outlet conforms to the
rating for the reel (see technical specifications for the reel).
The outlet must be a three-pronged grounded outlet.
2. Locate a ceiling beam (use a stud finder if needed) and install
the Hanger Hook (8) in the beam.
CAUTION: Drywall alone will not hold the weight of the reel.
Note: the reel can be installed by the mounting bracket is the
same way as a wall mount. See the steps in the wall mount
section below.
3. Hang the reel on the hook using the flying ring.
4. Use a pair of pliers to close the hook so the reel is secure and won’t slide off.
5. Adjust the cord stop so the triple tap hangs at a desired length when the cord is fully retracted.
6. Plug the lead-in cord into the outlet.
Wall Mount with the Mounting Bracket (Fig. 2)
1. Select an indoor wall location within 1 foot of an electrical
outlet.
CAUTION: Check that the power at the outlet conforms
to the rating for the reel (see technical specifications for
the reel). The outlet must be a three-pronged grounded
outlet.
2. Locate a wall beam (use a stud finder if needed).
CAUTION: Drywall alone will not hold the weight of the
reel.
3. Attach the U-shaped bracket (A) to the beam with the
screws provided.
4. Place the hanger bracket (2, B) on the reel casing inside
U-shaped bracket, lining up the small holes in the two
brackets.
5. Insert the locking pin (C) through the aligned holes.
6. Adjust the cord stop so the triple tap hangs at a desired length when the cord is fully retracted.
7. Plug the lead-in cord into the outlet.