Product Manual

Page 9 of 15
4. Reconnect the tube container to the main head. Press the locking plate to release the T-handle.
Press the handle in as far as it will go.
Make sure the end of the grease cartridge that is inserted into the tube container is not damaged or
squeezed. It should still be round and if not, the plunger will be prevented from entering the grease
cartridge. This will prevent the grease from exiting the tube.
Note: Do not re-use empty grease cartridges.
Suction Filling
1. Remove the tube container from the main head.
2. Submerge the open end of the tube container approximately 2 inches into the grease container.
3. Pull back slowly and extend the tube handle fully to draw grease upward into the tube container.
Lock the T-handle into place with the locking plate when it is fully extended.
4. Reassemble the tube container to the main head. Press the locking plate to release the T-handle.
Press the handle in as far as it will go.
Dispenser Filling
1. Pull back on the T-handle until it is fully extended. Lock it into place with the locking plate.
2. Insert the filler plug on the end of the hose of a filler pump (not included) and into the fill nozzle of
the grease gun.
3. Follow the operating instructions provided in the filler pump manual (not included) to work the filler
pump until the tube container of the grease gun is full.
4. Disconnect the grease gun from the filler pump.