Product Manual

Page 11 of 16
Before Each Use
Before installing the inverter, make sure the location meets the following conditions. This inverter has
a mounting bracket. To secure and fasten your inverter, please mount the inverter.
Dry
Don't drop or pour any liquid on the inverter.
Cool
Keep the inverter out of direct light.
Ventilated
Leave at least 2" of clearance around the inverter for air flow.
Make sure the ventilation openings are not obstructed.
Safe
Do not operate in the same compartment as stored
flammable liquids and gasoline.
Protect from
battery
gases
Do not operate in areas exposed to battery
gases. Prolonged exposure can damage the inverter.
Operating Instructions
⚠WARNING
Before connecting, make sure the cables will be connected correctly. If the poles of the battery are
reversely connected, the inverter will be damaged and the warranty does not cover such damage.
1. Turn ON the inverter’s power.
2. Plug in AC appliances one at a time with the highest load first.
3. Before disconnecting the inverter from the battery, make sure the inverter is turned OFF.
Note: If connected to a vehicle battery, constant use of the inverter will greatly affect the life of the
battery. Most vehicle batteries are not designed for constant, deep discharge. If you plan to use the
inverter for frequent extended periods of time, consider using a separate battery for the inverter.
Note: Most devices require an initial surge of power to start. Most devices can be started up with two
times their power rating. Be aware of the start-up power of the device(s) you intend to use for the
inverter. This inverter has the start-up capacity two times of rated power. The combined loads must
not exceed rated power. The less combined wattage used, the longer the inverter will operate before
the battery needs to be recharged.
After Each Use
When the inverter is not in use, disconnect the DC cable clips from the battery to prevent a slight
discharge of battery.
Maintenance
The inverter will operate efficiently when maintained properly. Follow these steps:
 Clean the exterior surface of the inverter with a damp cloth to prevent accumulation of dust and
dirt.