Product Manual

Page 11 of 28
deflection, heat build-up, and increased exhaust back-pressure, resulting in possible exhaust
leakage or damage to the generator.
Grounding the Generator
Always ensure the generator is properly grounded to prevent electrical shock. You must always
ground the generator by the following method when using the generator as a portable electrical
source:
1. Drive a ¾” or 1” copper pipe or rod into the ground close to the generator. The pipe/rod must
penetrate moist earth – the depth required will be dictated by local soil conditions. Consult with an
electrician.
2. Connect an approved ground clamp to the pipe.
3. Run a 10 gauge wire from the clamp to the generator grounding post located on the rear of the
generator head.
4. Do not connect the generator grounding post to a water pipe or a ground used by a radio system.
If a licensed electrician installs the generator with a connection to your building’s electrical circuit for
use as a back-up power system, grounding may alternatively be completed through the building’s
grounding system. Ask your electrician. If the generator is not grounded through your building’s
electrical system, follow the procedure above.
⚠WARNING
Operating the generator when it is not properly grounded can result in electrical shock.