Product Manual

Page 13 of 18
Troubleshooting
Use the table below to troubleshoot problems before contacting service personnel or your local
dealer. If the problem continues after troubleshooting, call your local dealer for assistance.
Failure
Possible Cause
Corrective Action
Tool will not start.
Cord not connected.
Check that cord is plugged in to power
source.
Internal damage or wear.
Have a technician service the tool.
Attachment is
loose on the tool.
Holes on attachment not lined up with
pins on spindle.
Remove the attachment and re-mount.
Performance
decreases over
time.
Attachment dull or damaged.
Keep cutting accessories sharp. Replace
as needed.
Carbon brushes worn or damaged.
Have a qualified technician replace
brushes.
Tool is
overheating
Forcing tool to work too fast.
Allow tool to work at its own rate.
Attachment dull or damaged.
Keep cutting accessories sharp. Replace
as needed.
Blocked motor housing vents.
Do no block the vents.