Product Manual

Page 7 of 12
A regular visual inspection is recommended. Ensure the solar panel is free from debris and in a
location where it will receive several hours of sunlight each day. Ensure the light is facing the desired
direction and that there are no nearby alternate light sources that may interfere with the motion
sensor.
Operating Instructions
1. Before the Solar Motion Light can operate to its full capacity, allow the unit to charge in sunlight
for 3 days with the solar panel wire connected to the light. Charging should be done with the unit
in the “OFF” position.
2. Located at the bottom of the Battery Housing there is am OFF/AUTO/ON switch:
 “AUTO” position, the light will turn on automatically when motion is detected.
 “ON” position, the light can be used as a standard light for constant illumination.
 “OFF” position, the light will remain off and will not detect any movement.
How to Use Control Dials
The Solar Motion Light has 3 dials which control the light’s duration,
sensitivity to light, and sensitivity to motion.
LUX (Light Level)
The LUX dial adjusts the sensitivity to darkness. If set to the maximum
level, the light will go on in daylight. If set to the minimum level,
the sensor will only trigger the light to turn on at dusk or when it is dark
out. This is the ideal position for general use. Please note that ambient
light will affect the sensor.
Time
The time dial sets the duration the light will stay on when triggered. The duration is adjustable from 5
seconds to 2 minutes. Rotating the dial clockwise will increase the duration the light will stay on.
SENS (Sensitivity)
The SENS dial adjusts the sensitivity of motion
detection:
1. Minimum position – Low Range: large movement
is required to trigger the light to turn on.
2. Mid Position - Medium setting.
3. Maximum position - Maximum range: the smaller movements will trigger the light to turn on.