Product Manual

Page 6 of 12
 Make sure it is clear of obstacles such as cables and electric lines.
 Secure lamp to the wall with the screws provided.
 Carefully route the wire from the solar panel to the lamp and plug it into the battery
housing input.
 Adjust the motion sensor so that it faces the area where motion detection is desired. You
can move it up and down by adjusting the screw on the neck of the motion detector.
Note: The lamp unit should be mounted 6.5-9 feet (2-3 meters), from the ground to ensure motion
detection is optimized.
2. Wall or deck mounting of solar panel
 Secure the bracket to the solar panel with the screw provided (shown below).
 Set the bracket on the surface and secure in place with larger screws provided.
 Adjust the angle of the solar panel to ensure it receives optimum sunlight.
Note: The Solar Panel is equipped with a length of wire. Ensure that the wire will reach the desired
position of the lamp before making the final installation.
Before Each Use
⚠WARNING
Solar lights require sunlight to function properly. Extended periods of cloudy weather will cause
shorter runtimes. Shade on the solar panel is to be avoided. The solar panel may be cleaned with
a clean damp cloth. Do not use soap, solvents, or abrasives.